It appears that you're trying to check the status of a service named cl_plus_sender and the check has returned a status of "FAILED." This indicates that the service may not be present, enabled, or active on your system.

Here are steps you can take to investigate and potentially resolve the issue:

1. Check Service Status: To check the status of the cl_plus_sender service, you can use a command like systemctl (assuming you're on a system that uses systemd):

   bash

• systemctl status cl_plus_sender

  This will provide information about whether the service is active, and enabled, and if there are any errors or warnings.

• Verify Service Name: Make sure that cl_plus_sender is the correct service name. It's possible that there may be a typo in the service name or it could be a custom service specific to your environment.

• Check if the Service is Installed: Verify if the cl_plus_sender service is actually installed on your system. You can do this by listing all active services:

  bash
• systemctl list-units --type=service

  Look for cl_plus_sender in the list.

• Check Logs: Check the logs related to the cl_plus_sender service for any error messages or indications of why it may have failed:

  bash
• journalctl -u cl_plus_sender

• Start/Enable the Service: If the service is installed but not active or enabled, you can start and enable it using the following commands:

  bash