To install DB Governor using the command line, you'll typically follow these steps:

1. Enable the CloudLinux repository (if not already enabled):

   Before installing DB Governor, you need to ensure that the CloudLinux repository is enabled on your system. You can do this by creating a repository configuration file. Run the following command:

   bash

• echo -e "[cloudlinux]\nname=CloudLinux $releasever - $basearch\nbaseurl=http://repo.cloudlinux.com/cloudlinux/$releasever/base/$basearch/\nenabled=1\ngpgcheck=1\ngpgkey=http://repo.cloudlinux.com/cloudlinux/$releasever/base/$basearch/RPM-GPG-KEY-CloudLinux\n" > /etc/yum.repos.d/cloudlinux.repo

  Be sure to replace $releasever and $basearch with the appropriate values for your system.

• Update the package list:

  Run the following command to make sure your system has the latest information about available packages:

  bash
• yum update

• Install MySQL Governor:

  Run the following command to install MySQL Governor:

  bash
• yum install governor-mysql

• Start the MySQL Governor service:

  Once the installation is complete, start the MySQL Governor service:

  bash
• systemctl start governor-mysql

• Enable MySQL Governor to start on boot:

  To ensure that MySQL Governor starts automatically whenever your server reboots, run the following command:

  bash
• systemctl enable governor-mysql

• Verify the installation:

  You can check the status of the MySQL Governor service to ensure it's running without any issues:

  bash